Pipe Insulation
260126 DO-IT-BEST/HWI PRODUCTS
12-OZ FIREBLOCK SPRAY FOAM SEALANT - JWH260126>
261041 DO-IT-BEST/HWI PRODUCTS
12-OZ " GREAT-STUFF" INSULATING FOAM. USE TO FILL GAPS, CRACKS, HOLES TOO LARGE FOR CAULK.EXPANDS 3" TIMES ORIGINAL VOLUME. PRODUCES AN AIRTIGHT WATER RESISTANT SEAL-JWH261041 >
287601 DO-IT-BEST/HWI PRODUCTS
GREAT STUFF WINDOW/DOOR FOAM SEALANT. SEAL THE GAP BETWEEN THE ROUGH OPENING AND THE WINDOW OR DOOR. GIVES YOU AN AIR TIGHT SEAL-JWH287601 >
420280 DO-IT-BEST/HWI PRODUCTS
PIPE WRAP INSULATION TAPE IS A SELF ADHESION VINYL FOAM AND ALUMINUM FOIL TAPE TO INSULATE HOT AND COLD WATER PIPES. TO PREVENT HEAT LOSS AND SWEATING AND DRIPPING ON COLD PIPE. SOLD IN ROLL SIZING 2" WX1/8" TEEX15'L.-JWH420280 >
534933 DO-IT-BEST/FROST KING 1" X 3" X 25' WALL FIBERGLASS PIPE INSULATION WRAP
INSULATES PIPES IN EXPOSED AREAS. STOPS SWEATING AND DRIPPING ON COLD PIPES. STOPS WASTEFULE HEAT LOSS ON HOT WATER PIPES
JWH534933 >
Recently Viewed
Proto® TorquePlus™ J5800 Standard Length Socket, Imperial, 1 in Square Drive, 3-1/8 in
RIDGID® 37405 12-R Hand Threader Die Head, 1-1/4 in Nominal, NPT Thread, Right Thread, Alloy Steel Die, For Use With Ridgid® 12-R Manual Pipe Threaders
RIDGID® 37405 12-R Hand Threader Die Head, 1-1/4 in Nominal, NPT Thread, Right Thread, Alloy Steel Die, For Use With Ridgid® 12-R Manual Pipe Threaders
RIDGID® 37380 12-R Hand Threader Die Head, 1/4 in Nominal, NPT Thread, Right Thread, Alloy Steel Die, For Use With Ridgid® 12-R Manual Pipe Threaders
RIDGID® 37380 12-R Hand Threader Die Head, 1/4 in Nominal, NPT Thread, Right Thread, Alloy Steel Die, For Use With Ridgid® 12-R Manual Pipe Threaders
Mayhew™ 62214 Center Punch Kit, 5 Pieces
DeWalt® Rock Carbide™ SDS Plus® hammer bit. Rock Carbide™ tip maximizes carbide surface contact for longer bit life. 4-flute design cleans debris out for fast, efficient drilling.
Drillco 350E003 3500E Imperial Plain Combined Drill and Countersink, 7/64 in Drill - Fraction, 0.1094 in Drill - Decimal Inch, 60 deg Included Angle, 60 deg Point Angle, HSS, Uncoated
When metal parts are machined on centers, as in turning or cylindrical grinding, it is always necessary to drill and countersink the center holes to serve as seats or bearings in the machine centers.
