HCI PREFERRED SUPPLIER

7" INTERNAL RETAINING RING 5000-700

7/16" STEEL BALLS-SSB716 >

7/16" X 36" O-1 OILHARD DRILLROD-DRI7/1601 >

7/16" IWRC IMPORTED WIRE ROPE 200(FT)-SWC7/16200 >

7/16" IWRC IMPORTED WIREROPE (FT)-SWC716250 >

7/16" IWRC IMPORTED WIREROPE (FT)-SWC71646 >

7/16" IWRC IMPORTED WIREROPE (FT)-SWC7/1698 >

7/16" 2-PIECE CLAMP SHAFT COLLAR

THE BASIC E-CLIP PROVIDES RELATIVELY LARGE SHOULDER HEIGHT FOR A SMALL SHAFT DIAMETER. ONLY GROOVE SIZE IS CRITICAL WITH THIS TYPE OF CIRCLIP, THE SHAFT DIAMETER CAN BE VARIED WIDELY

CONSTRUCTED AS CURVED BEAMS OF UNIFORM STRENGTH, THE RADIAL WIDTH IS REDUCED TOWARDS THE FREE ENDS SO THAT A CONSTANTLY ROUND SHAP IS MAINTAINED THROUGHOUT CONTINUOUS USE. THIS FORM OF CIRCLIP OFTEN USED IN ASSEMBLIES SUBJECTED TO STRONG CENTRIFUGAL FORCES, IS ALSO SECURE AGAINST HIGH ROTATIONAL SPEEDS. LUGS WITH HOLES ARE PROVIDED FOR RAPID FITTING OR REMOVAL WITH CIRCLIP PLIERS

RETAINING RINGS ARE PRECISION-ENGINEERED COMPONENTS, WHICH WHEN APPLIED IN BORES PROVIDES A SHOULDER THAT ACCURATELY POSITIONS, LOCATES OR RETAINS OTHER PARTS AND ASSEMBLY. THEY CAN BE USED TO REPLACE PINS AND WASHERS, THREADED SECTIONS, COLLARS, MACHINE SHOULDERS, AND OTHER COSTLY OR TIME-CONSUMING METHODS

7/16"-ID STAINLESS STEEL SHAFT COLLAR

7/16" -ID SOLID SHAFT COLLARS

7/32" X 36" O-1 OILHARD DRILLROD-DRI7/32O1 >

7/32" CHAINSAW FILE #168-8-5.5-1P-WIN732 >

THE BASIC E-CLIP PROVIDES RELATIVELY LARGE SHOULDER HEIGHT FOR A SMALL SHAFT DIAMETER. ONLY GROOVE SIZE IS CRITICAL WITH THIS TYPE OF CIRCLIP, THE SHAFT DIAMETER CAN BE VARIED WIDELY

7/8" X 36" O-1 OILHARD DRILLROD-DRI7/801 >

7/8" IWRC IMPORTED WIREROPE (FT)-SWC78150 >

7/8" IWRC IMPORTED WIREROPE (FT)-SWC78200 >

7/8" IWRC IMPORTED WIREROPE (FT)-SWC78500 >

7/8" IWRC IMPORTED WIREROPE (FT)-SWC7890 >

A 7/8-inch A2 drill rod is an air-hardening, precision-ground tool steel round bar commonly used for punches, shafts, and dies.

THE BASIC E-CLIP PROVIDES RELATIVELY LARGE SHOULDER HEIGHT FOR A SMALL SHAFT DIAMETER. ONLY GROOVE SIZE IS CRITICAL WITH THIS TYPE OF CIRCLIP, THE SHAFT DIAMETER CAN BE VARIED WIDELY

CONSTRUCTED AS CURVED BEAMS OF UNIFORM STRENGTH, THE RADIAL WIDTH IS REDUCED TOWARDS THE FREE ENDS SO THAT A CONSTANTLY ROUND SHAP IS MAINTAINED THROUGHOUT CONTINUOUS USE. THIS FORM OF CIRCLIP OFTEN USED IN ASSEMBLIES SUBJECTED TO STRONG CENTRIFUGAL FORCES, IS ALSO SECURE AGAINST HIGH ROTATIONAL SPEEDS. LUGS WITH HOLES ARE PROVIDED FOR RAPID FITTING OR REMOVAL WITH CIRCLIP PLIERS.