HCI PREFERRED SUPPLIER

10.1-OZ WOODY ACRYLIC LATEX CAULK-M-D22640 >

10.1-OZ GRAY ACRYLIC LATEX CAULK-M-D22665 >

10.1-OZ ALMOND ACRYLIC LATEX CAULK-M-D22681 >

25-BLADE METRIC FEELER GAUGE SETS-KD-2274>

OIL SEALS-2.283" X 2.953" X .315"-IMS22822>

OIL SEALS-2.281" X 3.154" X .375"-IMS22835>

1-OZ EYE WASH SOLUTION-CER229050 >

14-MM X 1.25 PERMA PLUG TOOL

22X22X12" CORRUGATED BOX-PCA22X22X12 >

30" DUSTMOP METAL FRAMES

1/16" X 1/8" COATED AIRCRAFT CABLE (FT)-TCI23002 >

2-3/4" URETHANE-FACE HAMMERS

1/8" RED VINYL COATED CABLE 7X19 TOOTHCI23006R >

CLEAR UPSIDE DOWN MARKING SPRAY PAINT-RUS2301 >

2" X 360" 2-PLY TWISTED-EYE NYLON SLING - SWC23021 >

STR-ID SPHERICAL ROLLER BEARINGS

1/2" TAP SET

STR-ID SPHERICAL ROLLER BEARINGS

STRAIGHT-ID SPHERICAL ROLLER BEARING-GUL23028 >

TPR-ID SPHERICAL ROLLER BEARINGS

OIL SEALS-2.313" X 2.997" X .375"-IMS23030>

Radial shaft seal with metal case and SKF Wave lip, for oil or grease
Radial shaft seals are used between rotating and stationary machine components, or between components in relative motion. CRW1 seals are designed with a metal case, an SKF WAVE lip made of elastomer with higher pumping rate to reduce heat generation, and a garter spring to optimize sealing against the shaft. Most of the seals feature the SKF Bore Tite coating on the outside diameter that helps fill small imperfections in the housing bore.
For oil or grease
With garter spring
WAVE lip creates higher pumping rate
WAVE lip has less friction between shaft and lip
WAVE lip has a lower temperature at the contact point

TPR-ID SPHERICAL ROLLER BEARINGS

Inner Diameter (Bore): 150 mm Outer Diameter: 225 mm Width: 56 mm Bore Type: Tapered (K = taper 1:12) Design Features: Self-aligning, accommodates heavy radial and axial loads in both directions, typically includes an annular lubrication groove with three holes in the outer ring (W33 variant).