Conduit Locknuts
Appleton® BL75 Conduit Locknut, 3/4 in, For Use With IMC/Rigid Conduit Fittings, Steel
Appleton® BL75 Conduit Locknut, 3/4 in, For Use With IMC/Rigid Conduit Fittings, Steel
Steel City® LN106-1 Conduit Locknut, 2 in, For Use With Rigid/IMC Conduit, Steel, Zinc Plated
Steel City® LN106-1 Conduit Locknut, 2 in, For Use With Rigid/IMC Conduit, Steel, Zinc Plated
Recently Viewed
Diversitech 108-130330 Variable Motor Start Capacitor, 108 to 130 uF, 330 V AC, Round
Diversitech 108-130330 Variable Motor Start Capacitor, 108 to 130 uF, 330 VAC, Round
Sealmaster® 710369 NPL Standard-Duty Pillow Block Ball Bearing Unit, 20 mm Dia Bore, 85.7 to 104.8 mm L Bolt Center-to-Center, 31.8 mm Base to Bore Centerline, 127 mm OAL x 58.7 mm OAH
Sealmaster® gold mounted ball bearings feature a wide outer race insert bearing with land riding metallic retainer. The black oxide treated bearing steel insert features an exclusive lock pin and dimple system providing a direct path for lubrication into the bearing, and prevents outer ring rotation within the housing. Shaft lock is achieved by either setscrew or Skwezloc® concentric locking collar. The felt seal with flinger provide a good balance between contaminant entry, GoldPlex® HP grease loss and friction. Depending on your preference, these bearings are available in both inch and metric shaft sizes with a wide variety of cast iron, stamped steel or rubber mount housings, sealing, and lubrication options or industry specific solutions.
V-826 KEYED ALIKE DRAWER LOCKS-NTL185298 >
HCI Preferred Supplier 32559 Smooth Hose Ferrule, 0.56 in Nominal, 1 in L, 0.025 mm THK, ASTMB36 Alloy 268 Brass
HCI Preferred Supplier 32559 Smooth Hose Ferrule, 0.56 in Nominal, 1 in L, 0.025 mm THK, ASTMB36 Alloy 268 Brass
THE BASIC E-CLIP PROVIDES RELATIVELY LARGE SHOULDER HEIGHT FOR A SMALL SHAFT DIAMETER. ONLY GROOVE SIZE IS CRITICAL WITH THIS TYPE OF CIRCLIP, THE SHAFT DIAMETER CAN BE VARIED WIDELY
-ANR150015 >
8" X 1.75" X 1/2"-ID PLASTIC WHEEL-MAT875POFSTG>
