Unground Thrust Bearings
The 600® Series bearing is designed for moderate speeds and medium thrust loads. These bearings utilize a full ball complement. Rings are cold forged from hardenable strip steel and are carefully heat treated. These bearings may be plated or manufactured from stainless steel upon request. The entire assembly is housed in a soft steel band which lends itself to an easy press fit into a housing. The band also serves as a dust shield and helps retain the bearing lubricant. The upper ring is free to rotate in the band and has a close fit in the bore for the shaft. The lower ring is fixed in the band and has a shaft clearance in the bore.
The 600® Series bearing is designed for moderate speeds and medium thrust loads. These bearings utilize a full ball complement. Rings are cold forged from hardenable strip steel and are carefully heat treated. These bearings may be plated or manufactured from stainless steel upon request. The entire assembly is housed in a soft steel band which lends itself to an easy press fit into a housing. The band also serves as a dust shield and helps retain the bearing lubricant. The upper ring is free to rotate in the band and has a close fit in the bore for the shaft. The lower ring is fixed in the band and has a shaft clearance in the bore.
Recently Viewed
Grey Pneumatic 3/8" Drive x 3/8" Impact Quick Change Adapter Impact Socket. GP 1130QC
These adapters provide a "quick change" mechanism by the use of a sliding collar and two positive retention balls for fast change of a socket on the end of a tool anvil. Works with Impact tool anvils that have a clip retention device or pin hole. A pin hole type anvil and use of a pin and retaining o-ring recommended to secure this adapter to the anvil.
GP® 2918F Standard Length Driver, 1/2 in Drive Hex Drive, 9/16 in
Amperage Rating: 50 Amp Voltage Rating: 0–30 VDC / 120 VAC (Type I automatic reset) Design: Ignition-protected and weather-sealed for marine, heavy vehicle, and battery charger applications Terminals: Standard screw or 1/4"-28 stud style terminals
