title-custom

IKO AS1528 Thrust Washer, 15 mm ID x 28 mm OD, 1 mm W

Bearing Thrust Washers

$1.73

IKO AS1528 Thrust Washer, 15 mm ID x 28 mm OD, 1 mm W

Koyo TRA-1018 Double Direction Thrust Washer, 15.88 mm ID x 28.58 mm OD, 0.81 mm W

Bearing Thrust Washers

$1.73

Ideally, a thrust washer should be stationary with respect to and piloted by its supporting or backing member whether or not this is an integral part of the shaft or housing. There should be no rubbing action between the thrust washer and any other machine member. The economics of design, however, often preclude these ideal conditions and thrust washers must be employed in another manner. In such cases, design details should be determined in consultation with your representative.

Koyo TRA-1828 Double Direction Thrust Washer, 28.58 mm ID x 44.45 mm OD, 0.81 mm W

Bearing Thrust Washers

$1.73

Ideally, a thrust washer should be stationary with respect to and piloted by its supporting or backing member whether or not this is an integral part of the shaft or housing. There should be no rubbing action between the thrust washer and any other machine member. The economics of design, however, often preclude these ideal conditions and thrust washers must be employed in another manner. In such cases, design details should be determined in consultation with your representative.

Koyo TRB-2435 Double Direction Thrust Washer, 38.1 mm ID x 55.55 mm OD, 1.6 mm W

Bearing Thrust Washers

$3.68

Ideally, a thrust washer should be stationary with respect to and piloted by its supporting or backing member whether or not this is an integral part of the shaft or housing. There should be no rubbing action between the thrust washer and any other machine member. The economics of design, however, often preclude these ideal conditions and thrust washers must be employed in another manner. In such cases, design details should be determined in consultation with your representative.

Koyo TRC-2233 Double Direction Thrust Washer, 34.93 mm ID x 52.37 mm OD, 2.41 mm W

Bearing Thrust Washers

$5.63

Ideally, a thrust washer should be stationary with respect to and piloted by its supporting or backing member whether or not this is an integral part of the shaft or housing. There should be no rubbing action between the thrust washer and any other machine member. The economics of design, however, often preclude these ideal conditions and thrust washers must be employed in another manner. In such cases, design details should be determined in consultation with your representative.

Koyo TRC-2435 Double Direction Thrust Washer, 38.1 mm ID x 55.55 mm OD, 2.41 mm W

Bearing Thrust Washers

$5.63

Ideally, a thrust washer should be stationary with respect to and piloted by its supporting or backing member whether or not this is an integral part of the shaft or housing. There should be no rubbing action between the thrust washer and any other machine member. The economics of design, however, often preclude these ideal conditions and thrust washers must be employed in another manner. In such cases, design details should be determined in consultation with your representative.