3"
Recently Viewed
Milwaukee® 48-20-6713 Drill Bit, 5/8 in Drill Bit, 5/8 in Shank SDS-Plus Shank, 10 in D Cutting, 12 in OAL
The MILWAUKEE® SDS Plus Rebar Cutters are the toughest in rebar, delivering up to 3x life in rebar compared to competitive rebar cutters. These bits, designed with precision ground carbide for rebar only drilling, provide up to 10x faster drilling speeds in rebar vs. 4-cutter drill bits. Milwaukee SDS Plus Rebar Cutters are equipped with HAMMER GUARD™ protective shanks, preventing carbide teeth destruction from accidental use in rotary hammer mode, saving time and money. Deep debris channels provide the fastest rebar shard removal while double ejection slots allow for easy rebar slug removal. Available in sizes 3/8” – 1-1/2”, Milwaukee SDS Plus Rebar Cutters are the optimal solution for drilling embedded rebar for corded and cordless SDS Plus rotary hammers. For use in rebar only.
United Abrasives-SAIT 82230 EA-F Industrial Open Coated Industrial Shop Roll, 50 yd L x 2 in W, 220 Grit, Very Fine Grade, Aluminum Oxide Abrasive, Cloth Backing
United Abrasives-SAIT 82230 EA-F Industrial Open Coated Industrial Shop Roll, 50 yd L x 2 in W, 220 Grit, Very Fine Grade, Aluminum Oxide Abrasive, Cloth Backing
Milwaukee® 48-20-9010 SHOCKWAVE™ Single Ended Hammer Drill Bit, 1/4 in Drill Bit, 1/4 in Hex Shank, 2 in D Cutting, Carbide Cutting Edge, 4 in OAL
The MILWAUKEE® SHOCKWAVE™ Impact Duty Carbide Hammer Drill Bits are designed with sharpened carbide to deliver up to 9x longer life and 4x faster drilling into concrete. Engineered with a precision ground tip, these bits deliver faster starts and less walking in concrete, brick, and block. Wide flute design removes dust faster, reducing heat and delivering more holes per charge. Equipped with a ¼” Hex Shank, Milwaukee® SHOCKWAVE™ Impact Duty Carbide Hammer Drill Bits are the ideal solution for drilling in masonry materials with both impacts and hammer drills/drivers. Available in diameters up to 1/2 inch.
Alemite® 1743-B Straight Drive Fitting, 35/64 in OAL, 1/4 in L Shank, Trivalent Zinc Plated
Alemite® 1743-B Straight Drive Fitting, 35/64 in OAL, 1/4 in L Shank, Trivalent Zinc Plated
1/2" X 6" SHAFT CUSHGRIP NUTDRIVER-KLE6461/2 >
Milwaukee® 48-25-1122 Standard Drill Bit, 1-1/8 in Dia, 6 in OAL, 7/16 in Shank
Milwaukee® Selfeed drill bits deliver speed and endurance for repetitive drilling of large holes. Designed for any trade that demands woodcutting for installing pipe and conduit, Selfeed bits feed into work without pressure and provide faster boring of clean, accurate holes. The bits have improved balance with reduced runout, while the hex shank provides a secure gripping surface for the drill chuck. Every Milwaukee Selfeed drill bit is coated with a rust inhibitor. Built to last and designed to perform, these Selfeed bits are resharpenable so you can keep them cutting like new. Two feed screws are included.
